Dell Latitude CP M233XT Setup Guide - Page 4
IDE Controller Driver, In the Install Driver window, click the Have Disk
View all Dell Latitude CP M233XT manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
2. Turn on the computer undocked, and complete the operating system setup. For detailed information, see the Dell-Installed Microsoft Windows NT Workstation 4.0 Setup Guide. 3. If you plan to connect a C/Port APR to a network, go to step 6. If you plan to use a C/Dock Expansion Station for any purpose, continue with step 4. 4. With the computer still undocked, install the driver for the IDE controller (CMD 646U Ultra DMA controller) that supports a CD-ROM drive in the C/Dock media bay. NOTE: You must install the IDE controller driver if you want to use the C/Dock Expansion Station with a network. For instructions, see the next subsecton, "IDE Controller Driver." 5. With the computer still undocked, install the driver for the SCSI controller (Adaptec AIC-7860 PCI SCSI controller). For instructions, see "SCSI Controller Driver" found later in this document. 6. Shut down the computer, dock it, and turn it on again. Follow the instructions on the display to load the appropriate drivers. 7. If you plan to connect the C/Dock Expansion Station or C/Port APR to a network, install the network driver. For instructions, see "Network Controller Driver" found later in this document. 8. Create a hardware profile for use with the C/Dock Expansion Station or C/Port APR. For instructions, see "Setting Up a Hardware Profile" in the Windows NT documentation that accompanied the computer. IDE Controller Driver If your computer uses Windows NT, use the following procedure to install the driver for the IDE controller on the C/Dock Expansion Station. The IDE controller supports a CD-ROM drive in the C/Dock media bay. The diskettes you need in this procedure came with the C/Dock Expansion Station. NOTES: You must install the IDE controller driver if you want to use the C/Dock Expansion Station with a network. You must have administrator privileges to perform the following procedure. 1. Undock the computer. 2. Click the Start button, point to Settings, and click Control Panel. 3. Double-click the SCSI Adapters icon. 4. Click the Drivers tab and click Add. 5. In the Install Driver window, click the Have Disk button. 6. Insert the Dell Latitude C/Dock Expansion Station Windows NT 4.0 IDE Driver diskette into the computer's diskette drive. 7. In the Copy the manufacturer's files from box, type a:\ and click OK. 8. Highlight CMD CSA-646U Ultra DMA IDE Adapter and click OK. 9. Type a:\ and click Continue. 10. When prompted to restart the computer, remove the diskette and click Yes. After the driver is installed, you may configure it for maximum performance as follows: 1. Click the Start button and click Run. 2. Type cmdcfgnt.exe and click OK. 3. Click the General tab. 4. Select the PCI bus speed that matches that of the computer. To determine the PCI bus speed of the computer, see the section titled "Chip Set and Bus" in Appendix A of the Reference and Troubleshooting Guide that accompanied the Latitude CP computer. If a documentation update came with the computer, check whether a new PCI bus speed has been added. 5. To enable the DMA features of the controller, click the Enable DMA box so that a check mark appears in the box. 1-2 Dell Latitude CP Before You Turn On Your Computer