Dell Latitude D430 Service Manual - Page 34

Speaker - hard drive cable

Page 34 highlights

Back to Contents Page Speaker Dell™ Latitude™ D430 CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide. NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such as the back panel) on the computer. 1. Follow the instructions in "Before You Begin" on page 7. 2. Remove any installed PC Cards from the PC Card slot. 3. Remove any installed memory modules or Mini PCI cards (see Memory and Mini-Cards). 4. Remove the hard drive (see Hard Drive). 5. Remove the hinge cover (see Hinge Cover). 6. Remove the keyboard (see Keyboard). 7. Remove the internal card with Bluetooth® wireless technology (see Internal Card With Bluetooth® Wireless Technology). 8. Remove the display assembly (see Display Assembly). 9. Remove the palm rest (see Palm Rest). 10. Turn the palm rest upside down and disconnect the speaker connector from the system board. 11. Remove the two M2 x 3-mm speaker screws from the computer base. 1 speaker 4 bottom of palm rest 2 M2 x 3-mm speaker screws (2) 3 speaker cables routing Back to Contents Page

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37

Back to Contents Page
Speaker
Dell™ Latitude™ D430
1.
Follow the instructions in
"Before You Begin" on page 7
.
2.
Remove any installed PC Cards from the PC Card slot.
3.
Remove any installed memory modules or Mini PCI cards (see
Memory
and
Mini
-
Cards
).
4.
Remove the hard drive (see
Hard Drive
).
5.
Remove the hinge cover (see
Hinge Cover
).
6.
Remove the keyboard (see
Keyboard
).
7.
Remove the internal card with Bluetooth
®
wireless technology (see
Internal Card With Bluetooth
®
Wireless Technology
).
8.
Remove the display assembly (see
Display Assembly
).
9.
Remove the palm rest (see
Palm Rest
).
10.
Turn the palm rest upside down and disconnect the speaker connector from the system board.
11.
Remove the two M2 x 3-mm speaker screws from the computer base.
Back to Contents Page
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide.
NOTICE:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such
as the back panel) on the computer.
1
speaker
2
M2 x 3-mm speaker screws (2)
3
speaker cables routing
4
bottom of palm rest