Dell Latitude D430 Service Manual - Page 6

Internal Card With Bluetooth, Wireless Technology - internal battery

Page 6 highlights

Back to Contents Page Internal Card With Bluetooth® Wireless Technology Dell™ Latitude™ D430 CAUTION: Before performing the following procedures, read the safety instructions in your Product Information Guide. NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching a connector on the back panel of the computer. NOTICE: To prevent damage to the system board, remove the main battery before you service the computer. If you ordered an internal card with Bluetooth wireless technology with your computer, it is already installed. 1. Follow the procedures in "Before You Begin" on page 7. 2. Remove the hinge cover (see Hinge Cover). 3. Remove the keyboard (see Keyboard). 4. Remove the M2 x 3-mm screw from the card holder and lay the holder aside. 5. Lift the card away from the aligning pin. 6. Disconnect the card cable connector from the card. 1 internal card with Bluetooth wireless technology 4 card holder 2 card cable connector 5 aligning pin 3 M2 x 3-mm screw NOTICE: Be careful when removing the card to avoid damaging the card, card cable, or surrounding components. Back to Contents Page

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37

Back to Contents Page
Internal Card With Bluetooth
®
Wireless Technology
Dell™ Latitude™ D430
If you ordered an internal card with Bluetooth wireless technology with your computer, it is already installed.
1.
Follow the procedures in
"Before You Begin" on page 7
.
2.
Remove the hinge cover (see
Hinge Cover
).
3.
Remove the keyboard (see
Keyboard
).
4.
Remove the M2 x 3-mm screw from the card holder and lay the holder aside.
5.
Lift the card away from the aligning pin.
6.
Disconnect the card cable connector from the card.
Back to Contents Page
CAUTION:
Before performing the following procedures, read the safety instructions in your Product Information Guide.
NOTICE:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching a connector on the back panel of
the computer.
NOTICE:
To prevent damage to the system board, remove the main battery before you service the computer.
1
internal card with Bluetooth wireless
technology
2
card cable
connector
3
M2 x 3-mm
screw
4
card holder
5
aligning pin
NOTICE:
Be careful when removing the card to avoid damaging the card, card cable, or surrounding components.