Dell MX9116n EMC SmartFabric OS10 User Guide Release 10.5.0 - Page 486

MST commands instance Configures MST instances and one or multiple VLANs mapped to the MST instance. Syntax Parameters instance instance-number {vlan vlan-range} • instance - Enter a MST instance value, from 0 to 63. For Z9332F-ON platform, enter a MST instance value from 0 to 61. • vlan range - Enter a VLAN range value, from 1 to 4093. Default Not configured Command Mode MULTIPLE-SPANNING-TREE Usage Information By default, all VLANs map to MST instance zero (0) unless you are using the vlan range command to map the VLANs to a non-zero instance. The no version of this command removes the instance-related configuration. Example OS10(conf-mst)# instance 1 vlan 2-10 OS10(conf-mst)# instance 2 vlan 11-20 OS10(conf-mst)# instance 3 vlan 21-30 Supported Releases 10.2.0E or later name Assigns a name to the MST region. Syntax name region-name Parameters region-name - Enter a name for an MST region. A maximum of 32 characters. Default System MAC address Command Mode MULTIPLE-SPANNING-TREE Usage Information By default, the MST protocol assigns the system MAC address as the region name. Two MST devices within the same region must share the same region name, including matching case. Example OS10(conf-mst)# name my-mst-region Supported Releases 10.2.0E or later revision Configures a revision number for the MSTP configuration. Syntax revision number Parameters number - Enter a revision number for the MSTP configuration, from 0 to 65535. Default 0 Command Mode MULTIPLE-SPANNING-TREE Usage Information To have a bridge in the same MST region as another, the default values for the revision number must match on all Dell EMC hardware devices. If there are non-Dell EMC devices, ensure the revision number value matches on all the devices. For more information, see Non-Dell Hardware. Example OS10(conf-mst)# revision 10 Supported Releases 10.2.0E or later 486 Layer 2