Dell MX9116n EMC SmartFabric OS10 User Guide Release 10.5.0 - Page 570

View password configuration in peer 2 OS10(config-router-neighbor)# show configuration ! neighbor 11.1.1.1 password 9 0fbe1ad397712f74f4df903b4ff4b7b6e22cc377180432d7523a70d403d41565 remote-as 20 no shutdown OS10(config-router-neighbor)# do show running-configuration bgp ! router bgp 20 neighbor 11.1.1.2 password 9 f785498c228f365898c0efdc2f476b4b27c47d972c3cd8cd9b91f518c14ee42d remote-as 20 no shutdown Fast external fallover Fast external fallover terminates EBGP sessions of any directly adjacent peer if the link used to reach the peer goes down. BGP does not wait for the hold-down timer to expire. Fast external fallover is enabled by default. To disable or re-enable it, use the [no] fast-external-fallover command. For the fast-external-fallover command to take effect on an established BGP session, you must reset the session using the clear ip bgp {* | peer-ipv4-address | peer-ipv6-address} command. View fast external fallover configuration OS10(config)# do show running-configuration bgp ! router bgp 300 ! neighbor 3.1.1.1 remote-as 100 no shutdown ! neighbor 3::1 remote-as 100 no shutdown ! address-family ipv6 unicast activate OS10(config)# interface ethernet 1/1/1 OS10(conf-if-eth1/1/1)# show configuration ! interface ethernet1/1/1 ip address 3.1.1.3/24 no switchport no shutdown ipv6 address 3::3/64 OS10(conf-if-eth1/1/1)# shutdown OS10(conf-if-eth1/1/1)# do show ip bgp summary BGP router identifier 11.11.11.11 local AS number 300 Neighbor AS MsgRcvd MsgSent Up/ Down State/Pfx 3.1.1.1 100 6 6 00:00:15 Active 3::1 100 8 11 00:00:15 Active OS10(conf-if-eth1/1/1)# View fast external fallover unconfiguration OS10(config-router-bgp-300)# do show running-configuration bgp ! router bgp 300 no fast-external-fallover ! neighbor 3.1.1.1 570 Layer 3