Dell MX9116n EMC SmartFabric OS10 User Guide Release 10.5.0 - Page 626

Example (IPv4) received from this neighbor are stored unmodified, regardless of the inbound policy. When inbound softreconfiguration is performed later, the stored information generates a new set of inbound updates. The no version of this command disables soft-reconfiguration inbound for a BGP neighbor. OS10(conf-router-neighbor)# address-family ipv4 unicast OS10(conf-router-bgp-neighbor-af)# soft-reconfiguration inbound Example (IPv6) OS10(conf-router-neighbor)# address-family ipv6 unicast OS10(conf-router-bgp-neighbor-af)# soft-reconfiguration inbound Supported Releases 10.3.0E or later template Creates a peer-group template to assign it to BGP neighbors. Syntax template template-name Parameters template-name - Enter a peer-group template name. A maximum of 16 characters. Default Not configured Command Mode CONFIG-ROUTER-BGP Usage Information Members of a peer-group template inherit the configuration properties of the template and share the same update policy. The no version of this command deletes a peer-template configuration. NOTE: To configure these settings for a nondefault VRF instance, you must first enter the ROUTER-CONFIG-VRF sub mode using the following commands: 1. Enter the ROUTER BGP mode using the router bgp as-number command. 2. From the ROUTER BGP mode, enter the ROUTER BGP VRF mode using the vrf vrf-name command. Example OS10(conf-router-bgp-10)# template solar OS10(conf-router-bgp-template)# Supported Releases 10.3.0E or later timers Adjusts BGP keepalive and holdtime timers. Syntax Parameters timers keepalive holdtime • keepalive-Enter the time interval, in seconds, between keepalive messages sent to the neighbor routers, from 1 to 65535. • holdtime-Enter the time interval, in seconds, between the last keepalive message and declaring a router dead, from 3 to 65535. Default keepalive 60 seconds; holdtime 180 seconds Command Mode ROUTER-BGP Usage Information The configured timer value becomes effective after a BGP hard reset. The timer values negotiate from peers. The no version of this command resets the value to the default. Example OS10(conf-router-bgp)# timers 30 90 Supported Releases 10.3.0E or later 626 Layer 3