Dell MX9116n EMC SmartFabric OS10 User Guide Release 10.5.0 - Page 964

Parameters interval-Enter the amount of time, in ms. This is the duration the switch waits between the connection attempts to the controller, from 1000 to 180000 ms. Default 8000 ms Command Mode CONFIGURATION-NVE-OVSDB Usage Information The no version of this command replaces the default maximum wait time configuration in the switch. Example OS10(config)# nve OS10(config-nve)# controller ovsdb OS10(config-nve-ovsdb)# max-backoff 40000 Supported Releases 10.4.3.0 or later nve-controller Assigns the interfaces to be managed by the controller. Syntax nve-controller Parameters None Default None Command mode INTERFACE Usage information The interface must be in Switchport Trunk mode when adding the interface to the controller. If the interface is not in the Switchport Trunk mode, the system displays the following error message: % Error: Interface ethernet1/1/1, must be in switchport trunk for controller mode. Example NOTE: If the interface has active port-scoped VLAN (Port,VLAN) pairs configured by the controller, you cannot remove an interface from the controller. The no version of this command removes the interface from the controller and removes any VXLAN binding associated with the interface. OS10(config)# interface ethernet 1/1/1 OS10(config-if-eth1/1/1)# nve-controller Supported releases 10.4.3.0 or later nve controller ssl-key-generate Generates the SSL certificate for the OVSDB server to setup the SSL connection with the controller. Syntax nve controller ssl-key-generate Parameters None Default None Command mode EXEC Usage information This command is available only for the sysadmin and secadmin roles. This command generates the SSL certificate and restarts the OVSDB server to start using the newly generated certificate. Example OS10# nve controller ssl-key-generate Supported releases 10.4.3.0 or later 964 VXLAN