Dell OptiPlex 5060 Small Form Factor Service Manual - Page 51
Installing the M.2 PCIe SSD, To remove the M.2 PCIe SSD
![]() |
View all Dell OptiPlex 5060 Small Form Factor manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 51 highlights
3. To remove the M.2 PCIe SSD: a. Remove the single (M2x3.5) screw that secures the M.2 PCIe SSD to the system board [1]. b. Lift and pull out the PCIe SSD from its connector on the system board [2]. c. Remove the SSD thermal pad [3]. Installing the M.2 PCIe SSD NOTE: The instructions are applicable to M.2 SATA SSD also. 1. Place the SSD thermal pad into the slot on the system board [1] . 2. Insert the M.2 PCIe SSD to the connector on the system board [2]. 3. Replace the single (M2x3.5) screw that secures the M.2 PCIe SSD to the system board [3]. Removing and installing components 51
![](/manual_guide/products/dell-optiplex-5060-small-form-factor-service-manual-97f8f7e/51.png)
3.
To remove the M.2 PCIe SSD:
a.
Remove the single (M2x3.5) screw that secures the M.2 PCIe SSD to the system board [1].
b.
Lift and pull out the PCIe SSD from its connector on the system board [2].
c.
Remove the SSD thermal pad [3].
Installing the M.2 PCIe SSD
NOTE:
The instructions are applicable to M.2 SATA SSD also.
1.
Place the SSD thermal pad into the slot on the system board [1] .
2.
Insert the M.2 PCIe SSD to the connector on the system board [2].
3.
Replace the single (M2x3.5) screw that secures the M.2 PCIe SSD to the system board [3].
Removing and installing components
51