Dell OptiPlex 5060 Small Form Factor Service Manual - Page 62
Installing the system board, Replace the standoff single #6-32 screw
View all Dell OptiPlex 5060 Small Form Factor manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 62 highlights
Installing the system board 1. Hold the system board by its edges, and align it towards the back of the system. 2. Lower the system board into the system chassis until the connectors at the back of the system board align with the slots on the chassis, and the screw holes on the system board align with the standoffs on the system chassis [1,2]. 3. Replace the standoff single (#6-32) screw, the single screw used as a mounting point for M.2 SSD drive and the 5 screws that secure the system board to the system [1, 2, 3][1,2]. 62 Removing and installing components
Installing the system board
1.
Hold the system board by its edges, and align it towards the back of the system.
2.
Lower the system board into the system chassis until the connectors at the back of the system board align with the slots on
the chassis, and the screw holes on the system board align with the standoffs on the system chassis [1,2].
3.
Replace the standoff single (#6-32) screw, the single screw used as a mounting point for M.2 SSD drive and the 5 screws
that secure the system board to the system [1, 2, 3][1,2].
62
Removing and installing components