Dell OptiPlex 7020 Tower OptiPlex 7020 Mini Tower Owners Manual - Page 28
Installing the Input/Output (I/O) Panel, Removing the System Board
View all Dell OptiPlex 7020 Tower manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 28 highlights
Installing the Input/Output (I/O) Panel 1. Insert the I/O panel into the slot on the chassis front. 2. Slide the I/O panel towards the right of the computer to secure to the chassis. 3. Tighten the screw to secure the I/O panel to the chassis. 4. Thread the I/O panel, data cable and USB data cable into the chassis clip. 5. Connect the I/O panel, data cable and USB data cable to the system board. 6. Install : a. front bezel b. cover 7. Follow the procedures in After Working Inside Your Computer. Removing the System Board 1. Follow the procedures in Before Working Inside Your Computer. 2. Remove the: a. cover b. memory c. expansion card(s) d. heat-sink assembly e. processor 3. Disconnect all the cables from the system board. 4. Remove the screws that secure the system board to the computer and slide the system board towards the front of the computer. 28