Dell PowerConnect 3548 User's Guide - Page 39
Installing the PowerConnect 3524/P and PowerConnect 3548/P, Site Preparation, Unpacking
View all Dell PowerConnect 3548 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 39 highlights
Installing the PowerConnect 3524/P and PowerConnect 3548/P Site Preparation The Dell™ PowerConnect™ 3524 /P and PowerConnect 3548/P devices can be mounted in a standard 48.26-am (19-inch) equipment rack, placed on a tabletop or mounted on a wall. Before installing the unit, verify that the chosen location for installation meets the following site requirements: • Power - The unit is installed near an easily accessible 100-240 VAC, 50-60 Hz outlet. • General - The Redundant Power Supply (RPS) is correctly installed by checking that the LEDs on the front panel are illuminated. • PoE Models - The RPS is currently installed by checking that the PoE LEDs on the front panel are illuminated. • Clearance - There is adequate frontal clearance for operator access. Allow clearance for cabling, power connections, and ventilation. • Cabling - The cabling is routed to avoid sources of electrical noise such as radio transmitters, broadcast amplifiers, power lines, and fluorescent lighting fixtures. • Ambient Requirements - The ambient unit operating temperature range is 0 to 45ºC (32 to 113ºF) at a relative humidity of 10% to 90%, non-condensing. Unpacking Package Contents While unpacking the device, ensure that the following items are included: • Device/Switch • AC power cable • RS-232 crossover cable • Self-adhesive rubber pads Installing the PowerConnect 3524/P and PowerConnect 3548/P 39