Dell PowerConnect 5448 Command Line Interface Guide - Page 435
tunnel source, Console config, Console config-tunnel, Dell_Tunnel_Router
View all Dell PowerConnect 5448 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 435 highlights
User Guidelines • The ipv6 tunnel routers-dns command determines the string that the host uses for automatic tunnel router lookup in IPv4 DNS procedure. By default, the string 'ISATAP' is used for the corresponding automatic tunnel types. • Per tunnel only one string can represent the automatic tunnel router name. Using this command overwrites the existing entry. Example The following example configures a global string "Dell_Tunnel_Router" to represent a specific automatic tunnel router domain name.. Console (config)# interface tunnel 1 Console (config-tunnel)# tunnel isatap router Dell_Tunnel_Router tunnel source The tunnel source Interface Tunnel Configuration mode command sets the local (source) tunnel interface IPv4 address. Use the no form to delete the tunnel local address. Syntax • tunnel source { auto | ip-address ipv4-address} • no tunnel source • auto - The system minimum IPv4 address is used as the source address for packets sent on the tunnel interface. If the IPv4 address is changed then the local address of the tunnel interface is also changed. • ip4-address - Pv4 address to use as the source address for packets sent on the tunnel interface. The tunnel interface local address is not changed when the IPv4 address is moved to another interface. Default Configuration No source address is defined. Command Mode Interface Tunnel Configuration mode. User Guidelines • The configured source IPv4 address is used for forming the tunnel interface identifier. The interface identifier is set to the 8 least significant bytes of the SIP field of the encapsulated IPv6 tunneled packets. Tunnel 435