Dell PowerConnect 8100 User's Configuration Guide - Page 1014

console(config)#interface vlan 17 console(config-if-vlan17)#ip address 10.2.4.2 255.255.255.0 console(config-if-vlan17)#ipv6 address 3000:2:4::/64 eui64 console(config-if-vlan17)#ipv6 ospf console(config-if-vlan17)#ipv6 ospf areaid 2 console(config-if-vlan17)#exit 4 For IPv4: Configure the router ID, define an OSPF router, and define Area 1 as a stub., and define Area 2 as an NSSA. console(config)#router ospf console(config-router)#router-id 2.2.2.2 console(config-router)#area 0.0.0.1 stub console(config-router)#area 0.0.0.2 nssa 5 For IPv4: Enable OSPF for IPv4 on VLANs 10, 5, and 17 by globally defining the range of IP addresses associated with each interface, and then associating those ranges with Areas 1, 0, and 2, respectively. console(config-router)#network 10.1.2.0 0.0.0.255 area 0.0.0.1 console(config-router)#network 10.2.3.0 0.0.0.255 area 0.0.0.0 console(config-router)#network 10.2.4.0 0.0.0.255 area 0.0.0.2 6 For IPv4: Configure a metric cost to associate with static routes when they are redistributed via OSPF: console(config-router)#redistribute static metric 1 subnets console(config-router)#exit 7 For IPv6: Define an OSPF router. Define Area 1 as a stub and area 2 as a Not-So-Stubby-Area (NSSA). Configure a metric cost to associate with static routes when they are redistributed via OSPF: console(config)#ipv6 router ospf console(config-rtr)#router-id 2.2.2.2 console(config-rtr)#area 0.0.0.1 stub console(config-rtr)#area 0.0.0.2 nssa 1014 Configuring OSPF and OSPFv3