Dell PowerConnect 8100 User's Configuration Guide - Page 168

At this point, if Unit 2 is powered off or rebooted due to an unexpected failure, show switch gives the following output: console#show switch SW Management Standby Preconfig Plugged- Switch Code Status Status Model ID in Model Status Version ID 1 Stack Member PC8024 PC8024 OK 9.19.0.2 2 Unassigned PC8024 Not Present 0.0.0.0 3 Mgmt Switch PC8024 PC8024 OK 9.19.0.2 4 Stack Member PC8024F PC8024F OK 9.19.0.2 When the failed unit resumes normal operation, the previous configuration that exists for that unit is reapplied by the stack master. To permanently remove the unit from the stack, enter into Stack Config Mode and use the member command, as the following example shows. console#configure console(config)#stack console(config-stack)#no member 2 console(config-stack)#exit console(config)#exit console#show switch SW Management Standby Preconfig Plugged- Switch Status Status Model ID in Model Status ID 1 Stack Member PC8024 PC8024 OK 3 Mgmt Switch PC8024 PC8024 OK 4 Stack Member PC8024F PC8024F OK Code Version -------9.19.0.2 9.19.0.2 9.19.0.2 168 Managing a Switch Stack