Dell PowerConnect B-RX BigIron RX Series Configuration Guide v02.7.02 - Page 1187

Clearing RIPng routes from IPv6 route table 44 Syntax: [no] poison-local-routes To disable the sending of a triggered update, use the no version of this command. Clearing RIPng routes from IPv6 route table To clear all RIPng routes from the RIPng route table and the IPv6 main route table and reset the routes, enter the following command at the Privileged EXEC level or any of the Config levels of the CLI. BigIron RX# clear ipv6 rip routes Syntax: clear ipv6 rip routes Displaying RIPng information You can display the following RIPng information: • RIPng configuration • RIPng routing table Displaying RIPng configuration To display RIPng configuration information, enter the following command at any CLI level. BigIron RX# show ipv6 rip IPv6 rip enabled, port 521 Administrative distance is 120 Updates every 30 seconds, expire after 180 Holddown lasts 180 seconds, garbage collect after 120 Split horizon is on; poison reverse is off Default routes are not generated Periodic updates 0, trigger updates 0 Distribute List, Inbound : Not set Distribute List, Outbound : Not set Redistribute: CONNECTED Syntax: show ipv6 rip This display shows the following information: TABLE 178 RIPng configuration fields This field... Displays... IPv6 RIP status/port Administrative distance Updates/expiration Holddown/garbage collection The status of RIPng on the Brocade device. Possible status is "enabled" or "disabled." The UDP port number over which RIPng is enabled. The setting of the administrative distance for RIPng. The settings of the RIPng update and timeout timers. The settings of the RIPng hold-down and garbage-collection timers. BigIron RX Series Configuration Guide 53-1001810-01 1115