Dell PowerConnect B-RX BigIron RX Series Configuration Guide v02.7.02 - Page 745

Displaying RIP filters 24 TABLE 104 CLI display of neighbor filter information (Continued) This field... Displays... OSPF metric Neighbor filter table area Index Action Neighbor IP Address Shows what OSPF route map has been applied. The filter number. You assign this number when you configure the filter. The action the router takes for RIP route packets to or from the specified neighbor: • deny - If the filter is applied to an interface's outbound filter group, the filter prevents the router from advertising RIP routes to the specified neighbor on that interface. If the filter is applied to an interface's inbound filter group, the filter prevents the router from receiving RIP updates from the specified neighbor. • permit - If the filter is applied to an interface's outbound filter group, the filter allows the router to advertise RIP routes to the specified neighbor on that interface. If the filter is applied to an interface's inbound filter group, the filter allows the router to receive RIP updates from the specified neighbor. The IP address of the RIP neighbor. Clearing the RIP routes from the routing table Clearing all the routes from the routing table. To clear RIP local routes, enter a command such as the following. BigIron(config)#clear ip rip local routes Syntax: clear ip rip local routes To clear the RIP routes from the RIP database, enter a command such as the following. BigIron(config)# clear ip rip routes Syntax: clear ip rip routes / Use the ip address to specify which routes in the database you want to clear. Use the subnet mask to specify which subnets you want to clear. NOTE Using the clear ip route command will not clear routes learned through RIP. BigIron RX Series Configuration Guide 673 53-1001810-01