Dell PowerConnect B-RX BigIron RX Series Configuration Guide v02.7.02 - Page 744

24 Displaying RIP filters The commands apply route map map1 as route filters to routes learned from the RIP neighbor on port 1/2. Setting RIP timers You can set basic update timers for the RIP protocol. The protocol must be enabled in order to set the timers. To set the timers. BigIron RX(config) router rip BigIron RX(config-rip-router)# timers 50 Syntax: [no] timers Possible values: 3 - 21845 seconds Default: 30 seconds The command specifies how often RIP update messages are sent. Displaying RIP filters To display RIP filters, enter the following command at any CLI level. BigIron RX> show ip rip RIP Summary Default port 520 Administrative distance is 120 updates every 30 seconds, expire after 180 Holddown lasts 180 seconds, garbage collect after 120 Last broadcast 30, Next Update 29 Need trigger update 0, next trigger broadcast 1 Minimum update interval 25, Max update offset 5 Split horizon is on; poison reverse is off import metric 1 Default routes are accepted Prefix List, Inbound, Not set Prefix List, Outbound, Not set Redistribute: CONNECTED Metric : 0 Routemap : Not Set Static Metric : 1 Routemap : map1 .not defined. OSPF Metric : 1 Routemap : Not Set RIP Neighbor Filter Table Index Action Neighbor IP Address 1 permit any Syntax: show ip rip This display shows the following information. TABLE 104 CLI display of neighbor filter information This field... Displays... RIP Summary area Statis metric Shows the current configuration of RIP on the device. Shows the static metric configuration. ".not defined" means the route map has not been distributed. 672 BigIron RX Series Configuration Guide 53-1001810-01