Dell PowerConnect B-RX Multi-Service IronWare Software R02.7.02a Release Notes - Page 28

Software image installed on BigIron RX 02.5.00 02.5.00a 02.5.00b 02.5.00c 02.5.00d 02.5.00e 02.5.00f 02.5.00g 02.5.00h 02.5.00i 02.5.00j 02.6.00 02.6.00a 02.6.00b 02.6.00c 02.6.00d 02.6.00e 02.7.00 02.7.01 02.7.01a 02.7.01b 02.7.02 02.7.02a FPGA image SBRIDGE SBRIDGE SBRIDGE SBRIDGE SBRIDGE SBRIDGE SBRIDGE SBRIDGE SBRIDGE SBRIDGE SBRIDGE SBRIDGE SBRIDGE SBRIDGE SBRIDGE SBRIDGE SBRIDGE SBRIDGE SBRIDGE SBRIDGE SBRIDGE SBRIDGE SBRIDGE Compatible FPGA version 6 6 6 6 6 6 6 6 6 6 6 6 6 6 6 6 6 6 6 6 6 6 6 To upgrade the MBRIDGE FPGA image on a BigIron RX management module, you must perform the following general steps: 1. Determine the versions of the images currently installed on the BigIron RX management module using the show version command. 1. Place the new MBRIDGE FPGA image on a TFTP server to which the BigIron RX system has access or on a PCMCIA flash card inserted in slot 1 or 2. 2. Copy the MBRIDGE FPGA image from the TFTP server or a flash card in slot 1 or 2 to all management modules or a management module in a specified chassis slot. To perform this step, enter one of the following commands at the Privileged EXEC level of the CLI (example: BigIron RX#): • copy tftp mbridge MBRIDGE • copy slot1 | slot2 mbridge MBRIDGE 3. After the MBRIDGE upgrade is complete, the management module must be reloaded. 4. Verify that the MBRIDGE image(s) have been successfully copied to the specified interface module(s) by entering the following command at any level of the CLI: • show version Check for the MBRIDGE image version numbers in the output. See MBRIDGE. IronWare Software Release 02.7.02a for Brocade BigIron RX Series Swtches Release Notes v 1.0 Page 28 of 46