Dell PowerConnect B-RX Multi-Service IronWare Software R02.7.03a Release Notes - Page 30
Defects, Closed defects with code change in Multi-Service IronWare, R02.7.03a.
View all Dell PowerConnect B-RX manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 30 highlights
Defects NOTE: In the tables below, "Reported In Release" indicates the product and release that the defect was first identified. If the problem also appeared in other Brocade IP Products, the issue was addressed using the same defect ID. Closed defects with code change in Multi-Service IronWare R02.7.03a. Defect ID: DEFECT000316902 Technical Severity: High Summary: An LSA with a higher metric can prevent the route installation of an LSA which has a lower metric and broadcast address LS ID. Symptom: When a static route is added on one router, a route for the same network may disappear on another router. Probability: High Feature: OSPF Function: Redistribution Reported In Release: RX 02.7.00 Service Request ID: 260272 Defect ID: DEFECT000317027 Technical Severity: Medium Summary: Router sends duplicate multicast packets when IGMP Snooping and Sflow are enabled. Probability: Medium Feature: IPv4-MC IGMP Function: IGMPv1/v2 Protocol Reported In Release: RX 02.7.02 Service Request ID: 259119 Defect ID: DEFECT000318055 Technical Severity: Medium Summary: Removed ability to set temperature polling interval to zero using CLI. Probability: High Feature: SYSTEM Function: Temp sensor & Monitoring Reported In Release: RX 02.7.02 Service Request ID: 256590 Defect ID: DEFECT000318432 Technical Severity: Medium Summary: If "clock summer-time" is configured, then system reloads one hour later than the configured reload time using "reload at" command. Symptom: After configuring "clock summer-time" the system reloads one hour later than the configured reload time when using the "reload at" command. Probability: Low Feature: SYSTEM Function: TIMER Reported In Release: RX 02.7.02 Service Request ID: 262013 Defect ID: DEFECT000321237 Technical Severity: Medium Summary: When a stub area is configured the 'show ip ospf border-router' command incorrectly displays the area value. Probability: Medium Feature: OSPF Function: show commands Reported In Release: RX 02.7.02 Service Request ID: 262838 IronWare Software Release 02.7.03a for Brocade BigIron RX Series Swtches Release Notes v 1.0 Page 30 of 40