Dell PowerConnect B-RX Multi-Service IronWare Software R02.7.03a Release Notes - Page 38

Defect ID: DEFECT000301863 Technical Severity: High Summary: An OSPF route with metric of 65535 is not installed in the routing table. Symptom: Using the configuration 'auto-cost reference-bandwidth 100000' will prevent routes from a GRE tunnel interface from being installed. Workaround: Remove the auto-cost reference-bandwidth 100000 or set the cost on the GRE tunnel interface. Probability: High Feature: OSPF Function: PROTOCOL Reported In Release: RX 02.7.02 Service Request ID: 248796 Defect ID: DEFECT000302010 Technical Severity: Medium Summary: Inserted "0" to ipv6 prefix-list for fe80::/ Symptom: When IPv6 prefix list was created, only fe80::/ prefix list automatically inserted "0" to running-config. Probability: High Feature: IPV6 Function: Prefix-list Reported In Release: RX 02.7.02 Service Request ID: 246057 Defect ID: DEFECT000302184 Technical Severity: Medium Summary: System reloads due to an incorrect Management module sync message Probability: Low Feature: SYSTEM Function: Event Manager Reported In Release: RX 02.6.00 Service Request ID: 251711 Defect ID: DEFECT000302396 Technical Severity: Medium Summary: The RADIUS configuration is missing the auth-port keyword for ipv6 which can result in the command not getting parsed correctly on reload. Symptom: The RADIUS configuration is missing the auth-port keyword for IPv6 which can result in the command not getting parsed correctly on reload. telnet@XMR13(config)#radius-server host ipv6 fe80::2 ? DECIMAL Number Workaround: Need to re-enter radius-server CLI command every time after reload. Probability: High Feature: AAA Function: RADIUS Authentication Reported In Release: RX 02.7.02 Service Request ID: 247801 Defect ID: DEFECT000303316 Technical Severity: Medium Summary: The router may reload when issuing the "show media" command. Symptom: Reload Probability: Medium Feature: SYSTEM Function: I2C Reported In Release: RX 02.7.02 Service Request ID: 251305 Defect ID: DEFECT000303782 Technical Severity: High Summary: High CPU may occur when IGMP & PIM is configured. Symptom: Running PIM on multiple VLANs that have a large numbers of ports, the following message may be seen below every igmp query interval. "[mcast] ip_tx's Q is Full - max 65536, 65536, current 65512, 0" Probability: Medium Feature: IPv4-MC IGMP Function: SCALABILITY Reported In Release: RX 02.7.02 Service Request ID: 249377 IronWare Software Release 02.7.03a for Brocade BigIron RX Series Swtches Release Notes v 1.0 Page 38 of 40