Dell PowerConnect B-RX Multi-Service IronWare Software R02.7.03a Release Notes - Page 5

Supported devices for Multi-Service IronWare R02.7.03a This software release applies to the following Brocade products: • BigIron RX-4 Switch • BigIron RX-8 Switch • BigIron RX-16 Switch • BigIron RX-32 Switch Note: The software release described in these release notes can only be used on the devices specified above. All information required to operate the BigIron RX Series Switch is described in the BigIron RX Series Configuration Guide or the Brocade BigIron RX Series Installation Guide. Enhancements R02.7.03a There are no enhancements in R02.7.03a. R02.7.03 Enhancement Descriptions Described in... Support for active cable for 16-port 10 Gigabit Ethernet module 10 Gbps Direct Attached Small Form-Factor Pluggable (SFP+) copper cable (1m, 3m, 5m) is available for the 16-port 10 Gigabit Ethernet module Book: Brocade BigIron RX Series Installation Guide Monitoring I2C failure on a The show logging command can be use to management module monitor I2C failures. Book: Brocade BigIron RX Series Installation Guide Rebranded show version command output The output of the show version command now Book: Brocade BigIron RX Series shows "Brocade Communications" Installation Guide Rebranded RADIUS Vendor specific attributes for RADIUS have been renamed to "brocade-command-string", "brocade-privilege-level", and "brocadecommand-exception-flag" Book: BigIron RX Configuration Giuide Chapter: Securing Access to Management Functions Section: Configuring RADIUS security MAC Port Security The MAC Port Security feature has been updated for the 02.7.03 release. Book: BigIron RX Configuration Giuide Chapter: Using the MAC Port Security Feature and Transparent Port Flooding IronWare Software Release 02.7.03a for Brocade BigIron RX Series Swtches Release Notes v 1.0 Page 5 of 40