Dell PowerConnect B-RX Multi-Service IronWare Software R02.7.03a Release Notes - Page 39
IPv4-MC PIM-SM Routing, Multicast Boundary- TTL Threshold
View all Dell PowerConnect B-RX manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 39 highlights
Defect ID: DEFECT000305721 Technical Severity: Medium Summary: OSPF interface cannot be established between a VE interface on 16x10G linecard. This was seen when the 16x10G card is in an RX-4 system. Symptom: Unable to for a OSPF adjacency. Probability: High Feature: OSPF Function: PROTOCOL Reported In Release: RX 02.7.02 Service Request ID: 251533 Defect ID: DEFECT000306096 Technical Severity: High Summary: With Multicast enabled, traffic may stop forwarding due to buffer depletion. Symptom: Protocols went down due to buffer depletion. Probability: Low Feature: IPv4-MC PIM-SM Routing Function: SCALABILITY Reported In Release: RX 02.7.02 Service Request ID: 249142 Defect ID: DEFECT000306310 Technical Severity: Medium Summary: Console message "incomplete command" may be seen when configuring a remark parameter on named access-lists. Symptom: An error message is seen when configuring a ACL. Probability: Low Feature: ACL Function: IPv4 Reported In Release: RX 02.7.02 Service Request ID: 251509 Defect ID: DEFECT000306574 Technical Severity: Medium Summary: A static RP ACL fails to map if one of the RP ACLs is not defined. Symptom: ACL is not working correctly. Probability: Medium Feature: IPv4-MC PIM-SM Routing Function: Static RP Reported In Release: RX 02.7.02 Service Request ID: 255479 Defect ID: DEFECT000308240 Technical Severity: High Summary: An Interface module may reload if a trunk port with multicast boundary flaps. Symptom: Interface module reloads. Probability: Low Feature: IPv4-MC PIM-SM Routing Function: Multicast Boundary- TTL Threshold Reported In Release: RX 02.7.02 Service Request ID: 255504 Defect ID: DEFECT000308974 Technical Severity: Medium Summary: When a LAG is configured with a combination of 16x10G ports and 4x10G ports on the same chassis some protocols fail. Symptom: LAG across ports from both 16x10 and 4x10 line cards may stop forwarding traffic after some time. Workaround: Don't assign non 16x10 ports to a 16x10 LAG. Probability: Low Feature: LAG Function: Static Reported In Release: RX 02.7.02 Service Request ID: 251681 IronWare Software Release 02.7.03a for Brocade BigIron RX Series Swtches Release Notes v 1.0 Page 39 of 40