Dell PowerConnect B-RX Multi-Service IronWare Software R02.7.03a Release Notes - Page 36
Not able to set Extended IP ACL Protocol field to ESP50 from SNMP, Character I/O
View all Dell PowerConnect B-RX manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 36 highlights
Defect ID: DEFECT000284653 Technical Severity: Medium Summary: Not able to set Extended IP ACL Protocol field to ESP(50) from SNMP Symptom: Customer was trying to implement ACL to RX from INM but failed. Using CLI command the access list is added without any problem access-list 105 permit esp host 1.1.1.1 host 2.2.2.2 Probability: High Feature: SNMP Management Function: IP Mib Reported In Release: RX 02.7.02 Service Request ID: 241185 Defect ID: DEFECT000286364 Technical Severity: Medium Summary: Change gig auto negotiation behavior. Symptom: Currently, between two gig fiber interfaces, when one side is configured with gig-default auto (default), the other side is gig-default neg-off, links show up at both sides. Default behavior will change to the side with neg-off configured shows link up and the side with auto configured shows link down. In addition: gig-default auto-full is added to switch back to the current behavior (none-default behavior after the code change). Probability: Medium Feature: SYSTEM Function: OPTICS Reported In Release: RX 02.7.02 Service Request ID: 242203 Defect ID: DEFECT000287890 Technical Severity: Medium Summary: BGP "allowas-in" does not with confederation config Symptom: BGP Routes received from peer with local AS (in as-path) are dropped even though "allowas-in" is used for that particular peer. We have observed this issue only when confederation is configured. Without confederation it works fine. Probability: High Feature: BGP Function: BGPv4 Reported In Release: RX 02.7.00 Defect ID: DEFECT000288254 Technical Severity: High Summary: Under "ipv6 router ospf", the "in" parameter after a "distribute-list prefix-list" isn't saved to the running config. Symptom: Under "ipv6 router ospf", the "in" parameter after a "distribute-list prefix-list" isn't saved to the running config even though it is required when entering a "distribute-list prefix-list". As a result, the config is lost when the write mem command is issued and the device is reloaded. Probability: High Feature: OSPFv3 Function: CONFIGURATION Reported In Release: RX 02.7.02 Service Request ID: 245558 Defect ID: DEFECT000288573 Technical Severity: Medium Summary: LAG port name was only displayed up to 9 characters. Symptom: LAG port names are being cutoff in the show lag output. Probability: Medium Feature: Character I/O Function: Character Handling Reported In Release: RX 02.7.02 Service Request ID: 244909 IronWare Software Release 02.7.03a for Brocade BigIron RX Series Swtches Release Notes v 1.0 Page 36 of 40