Dell PowerConnect B-RX Multi-Service IronWare Software R02.8.00 Release Notes - Page 12

Software image files for Multi-Service IronWare R02.8.00 The following software image files are available for Multi-Service IronWare R02.8.00 for the BigIron RX Series switches. Table 3: Software image files Module Image type Image name Unified Image N/A Management Module Boot and Monitor IronWare BigIron RX-4, BigIron RX-8, and BigIron FPGA RX-16 BigIron RX-32 rx02800.bin rmb02800.bin rmpr02800.bin mbridge.xsvf mbridge32.xsvf Interface Module Boot and Monitor IronWare rlb02800.bin rlp02800.bin Images and procedures required The software images required and the procedures for upgrading have been changed as described in the following sections: • Upgrading software images based on version upgrade - This sub-section describes the procedures required for your software upgrade depending upon the version you are upgrading from or to. Links are provided to the required procedures. • Displaying the version information - This sub-section describes the commands that allow you to determine the contents of the flash memory in the BigIron RX Series switch and how to read the output of those commands. • Upgrading the device's monitor and Multi-Service IronWare image - This sub-section describes the procedures required for upgrading the BigIron RX Series switches monitor and Multi-Service IronWare image. • Upgrading the device's boot images - This sub-section describes the procedures required for upgrading the BigIron RX Series switches boot software images. [Upgrade required only if mentioned in Release Notes] IronWare Software Release 02.8.00 for Brocade BigIron RX Series Swtches Release Notes v 1.0 Page 12 of 37