Dell PowerConnect W-650 Installation Guide - Page 13
Pre-Installation Requirements, Installation in a Telecom Rack
View all Dell PowerConnect W-650 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
Chapter 2 W-650 Series Installation Pre-Installation Requirements The following tools and equipment are required for installation of a W-650 Series controller. z Rack Mount Bracket (x2, not used for tabletop installation) z Suitable Screwdrivers z AC Power Cord (country-specific) z Left and right side bezels (not used for rack mounting) Caution: Installation and service of Dell Networks products should be performed by Professional Installers. Additional antenna and transmit power information for Professional Installers can be found at https://support.dell.com. For a Telecom Rack: z M3, 6mm x 0.5mm Phillips Head Screws (6x, included) z 12-24 x 5/8" Phillips Head Screws (4x, included) For a Server Rack: z M3, 6mm x 0.5mm Phillips Head Screws (6x, included) z M6 x 20mm Phillips Head Screws (4x, included) z M6 Cage Nuts (4x, included) or M6 Cage Clips (4x, included) Installation in a Telecom Rack To install a W-650 Series controller into a 19-inch (48.26 cm) Telecom rack system: 1. Place a rack mount bracket over the mounting holes on one side of the controller (see Figure 6). 2. Secure the bracket to the controller using three M3, 6mm x 0.5mm phillips head screws and a screwdriver. 3. Repeat these steps on the opposite side of the controller. Dell PowerConnect W-650 Controller | Installation Guide W-650 Series Installation | 13