Dell PowerConnect W-AP134 Installation Guide - Page 6
Installing the AP
View all Dell PowerConnect W-AP134 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
Microwave ovens Wireless phones and headsets Installing the AP NOTE: Service to all Dell products should be performed by trained service personnel only. Using the Ceiling Rail Adapter The AP130 series ships with two ceiling rail adapters for 9/16" and 15/16" ceiling rails. CAUTION: Make sure the AP fits securely on the ceiling tile rail when hanging the device from the ceiling, because poor installation could cause it to fall onto people or equipment. 1. Pull the necessary cables through a prepared hole in the ceiling tile near where the AP will be placed. 2. Place the adapter against the back of the AP with the adapter at an angle of approximately 30 degrees to the tabs (see Figure 3). 3. Twist the adapter clockwise until it snaps into place in the tabs (see Figure 3). Figure 3 Attaching the Ceiling Rail Adapter AP-130_001 4. If necessary, connect the console cable to the console port on the back of the AP. 5. Hold the AP next to the ceiling tile rail with the ceiling tile rail mounting slots at approximately a 30-degree angle to the ceiling tile rail (see Figure 4). Make sure that any cable slack is above the ceiling tile. 6. Pushing toward the ceiling tile, rotate the AP clockwise until the device clicks into place on the ceiling tile rail. 6 Dell PowerConnect W-AP130 Series Access Point | Installation Guide