Dell PowerConnect W-AP134 Installation Guide - Page 7

Figure 4 Mounting the AP AP-130_002 7. On the W-AP134, install the external antennas according to the manufacturer's instructions, and connect the antennas to the antenna interfaces on the AP. Connecting Required Cables Install cables in accordance with all applicable local and national regulations and practices. Ethernet Ports The RJ45 Ethernet ports (ENET0 and ENET1) support 10/100/1000Base-T auto-sensing MDI/MDX connections. Use these ports to connect the AP to a twisted pair Ethernet LAN segment or directly to a Dell Controller. Use a 4- or 8-conductor, Category 5 UTP cable up to 100 m (325 feet) long. The 10/100/1000 Mbps Ethernet ports are on the bottom of the AP. These ports have RJ-45 female connectors with the pin-outs shown in Table 1. Table 1 Ethernet Port Pin-out Connector Pin Signal Name GE Connection FE Connection PoE 1 1 22 33 4 5 4 65 7 8 6 7 8 BI_DA+ BI_DA- BI_DB+ BI_DC+ BI_DC- BI_DB- BI_DD+ BI_DB- Bi-directional pair A+ Bi-directional pair A- Bi-directional pair B+ Bi-directional pair C+ Bi-directional pair C- Bi-directional pair B- Bi-directional pair D+ Bi-directional pair D- RX+ RX- TX+ Spare pair Spare pair TX- Spare pair Spare pair POE negative POE negative POE positive POE positive POE positive POE positive POE negative POE negative Dell PowerConnect W-AP130 Series Access Point | Installation Guide 7