Dell PowerConnect W-AP134 Installation Guide - Page 9

Verifying Post-Installation Connectivity The integrated LEDs on the AP can be used at this point to verify that the AP is receiving power and initializing successfully (see Table 3). Refer to the Dell PowerConnect W-Series ArubaOS 6.1 Quick Start Guide for further details on verifying post-installation network connectivity. Table 3 W-AP130 Series LED Behavior LED PWR ENET 0 (100/1000 Mbps) ENET 1 (100/1000 Mbps) 11A/N 11B/G/N Color/State Off Green steady Green flashing Red steady Green/Amber off Green on Amber on Green/amber blinking Green/Amber off Green on Amber on Green/amber blinking Off Amber Green steady Green flashing Off Amber Green steady Green flashing Meaning No power to AP Power on, device ready Device booting, not ready System failed to initialize No link 1000 Mbps link 10/100 Mbps link Link activity No Link 1000 Mbps link 10/100 Mbps link Link activity 5 GHz radio disabled 5 GHz radio enabled in 11a mode 5 GHz radio enabled in 11n mode 5 GHz Air Monitor mode 2.4 GHz radio disabled 2.4 GHz radio enabled in 11b/g mode 2.4 GHz radio enabled in 11n mode 2.4 GHz Air Monitor Mode Configuring the W-AP130 Series AP Provisioning/Reprovisioning Provisioning parameters are unique to each AP. These local AP parameters are initially configured on the Controller which are then pushed out to the AP and stored on the AP itself. Dell recommends that provisioning settings be configured via the ArubaOS WebUI only. Refer to the Dell PowerConnect W-Series ArubaOS 6.1 User Guide for complete details. AP Configuration Configuration parameters are network or controller specific and are configured and stored on the Controller. Network configuration settings are pushed out to the AP(s) but remain stored on the Controller. Dell PowerConnect W-AP130 Series Access Point | Installation Guide 9