Dell PowerConnect W Clearpass 100 Software D-Link DSA-3600 Integration Guide - Page 13

D-Link DSA-3600 Configuration

Get Dell PowerConnect W Clearpass 100 Software PDF manuals and user guides View all Dell PowerConnect W Clearpass 100 Software manuals
Add to My Manuals
Save this manual to your list of manuals

Page 13 highlights

D-Link DSA-3600 Configuration The following configuration procedure assumes that the D-Link DSA-3600 has been powered up and a basic IP configuration has been applied through the steps detailed in the Quick Install Guide. The following table again reviews the IP Addressing used in the test environment but this would be replaced with the site specific details of each customer deployment: DSA WAN1 IP Address DSA Default Service Zone IP Address Internet Gateway Address amigopod IP Address amigopod RADIUS port 10.0.20.166 192.168.1.1 10.0.20.1 10.0.20.54 Auth 1812 Acc 1813 (default settings) Depending on your network design the D-Link DSA-3600 may need to be configured to perform Network Address Translation (NAT) on the Internet port. As can be seen from the previous Lab Topology diagram, to simplify our lab routing environment NAT has been enabled. If NAT is required in your network design, the DSA NAT settings can be found under System!Service Zones!Default!Configure as shown below: CONFIDENTIAL 13

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
CONFIDENTIAL
13
D-Link DSA-3600 Configuration
The following configuration procedure assumes that the D-Link DSA-3600 has been powered up
and a basic IP configuration has been applied through the steps detailed in the Quick Install
Guide. The following table again reviews the IP Addressing used in the test environment but this
would be replaced with the site specific details of each customer deployment:
DSA WAN1 IP Address
10.0.20.166
DSA Default Service Zone IP Address
192.168.1.1
Internet Gateway Address
10.0.20.1
amigopod IP Address
10.0.20.54
amigopod RADIUS port
Auth 1812
Acc 1813 (default settings)
Depending on your network design the D-Link DSA-3600 may need to be configured to perform
Network Address Translation (NAT) on the
Internet
port. As can be seen from the previous Lab
Topology diagram, to simplify our lab routing environment NAT has been enabled.
If NAT is required in your network design, the DSA NAT settings can be found under
System
!
Service Zones
!
Default
!
Configure
as shown below: