Dell PowerConnect W Clearpass 100 Software D-Link DSA-3600 Integration Guide - Page 14

Default, WAN1 port, Administrator, Network Interfaces

Get Dell PowerConnect W Clearpass 100 Software PDF manuals and user guides View all Dell PowerConnect W Clearpass 100 Software manuals
Add to My Manuals
Save this manual to your list of manuals

Page 14 highlights

If your design requires the use of other Service Zones than the Default Service Zone then the NAT settings for these zones will also have to be updated. If you intend to run your network in a routed environment you will either need to update your routing tables on the default gateway router that is servicing the network the WAN1 port of the DSA is connected to and / or add a static route to the amigopod configuration. To add a static route to your amigopod install, browse to the Administrator!Network Interfaces menu option and select your active Ethernet adaptor. In our case eth1 is connected to the local lab network as shown below: CONFIDENTIAL 14

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
CONFIDENTIAL
14
If your design requires the use of other Service Zones than the
Default
Service Zone then the
NAT settings for these zones will also have to be updated.
If you intend to run your network in a routed environment you will either need to update your
routing tables on the default gateway router that is servicing the network the
WAN1 port
of the
DSA is connected to and / or add a static route to the amigopod configuration.
To add a static route to your amigopod install, browse to the
Administrator
!
Network Interfaces
menu option and select your active Ethernet adaptor. In our case
eth1
is connected to the local
lab network as shown below: