Dell PowerConnect W Clearpass 100 Software D-Link DSA-3600 Integration Guide - Page 16
Step 1 - Enable DHCP on LAN port
View all Dell PowerConnect W Clearpass 100 Software manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
Step 1 - Enable DHCP on LAN port In our Lab environment DHCP needs to be enabled on the Default Service Zone to provide IP addresses to both downstream D-Link Access Points and any wired clients connected to this interface of the DSA-3600. This is configured again under System!Service Zones!Default!Configure as shown in the following screen shot: CONFIDENTIAL 16
CONFIDENTIAL
16
Step 1 – Enable DHCP on LAN port
In our Lab environment DHCP needs to be enabled on the
Default Service Zone
to provide IP
addresses to both downstream D-Link Access Points and any wired clients connected to this
interface of the DSA-3600. This is configured again under
System
!
Service
Zones
!
Default
!
Configure
as shown in the following screen shot: