Dell PowerEdge 2850 Updating Your NIC Teaming Drivers (.pdf) - Page 10

www.dell.com | support.dell.com Figure 1-4. Removing the Expansion-Card Riser Board From a Dell PowerEdge 2850 System slots tabs RAID memory module connector expansion-card riser board retention pin RAID battery connector expansion-card guide expansion card openings expansion-card guide release tabs (2) 3 Remove the expansion-card riser board: a Pull the riser retention pin. See Figure 1-4. b While pulling the retention pin, slide the riser board away from the expansion card openings. c Lift the expansion-card riser board from the six securing tabs. 4 Place the riser board in the expansion-card cage so that the tabs are fully inserted in the slots on the riser board. See Figure 1-4. 5 Slide the riser board toward the expansion card openings until you feel the riser-board retention pin snap into place. 6 Close the expansion-card guide. 7 If applicable, reinstall the RAID memory module onto the riser board. 10 Upgrading Your System Board and Riser Board