Dell PowerEdge 4400 Microprocessor Upgrade Installation Guide - Page 19

(Rev. 11/3/98) FILE LOCATION: S:\SYSTEMS\SlimFast\ts\ProcUpgrade\028WD\028wdeb0.fm 5HSODFLQJ WKH 6(& &DUWULGJH DQG +HDW 6LQN $VVHPEO\ To install the replacement SEC cartridge and heat sink assembly, perform the following steps: 1. Remove the terminator card or old SEC cartridge from the guide bracket assembly. 2. Slide the SEC cartridge and heat sink assembly into the guide-bracket assembly until the edge connector on the SEC cartridge is firmly seated in the connector on the system board (see Figure 1-8). 3. Place the retention clips on each end of the guide bracket in the notches on the ends of the guide bracket, and then close the two latches to secure the SEC cartridge and heat sink assembly in the bracket. 4. Replace the cooling shroud and computer cover. heat sink SEC cartridge retention clips (2) guide bracket assembly latches (2) )LJXUH  5HSODFLQJ DQ 6(& &DUWULGJH DQG +HDW 6LQN $VVHPEO\ support.dell.com DELL CONFIDENTIAL - Preliminary 9/11/00 Microprocessor Upgrade Installation Guide 1-15