Dell PowerEdge 600SC Information Update - Page 5
Table, IDE Drive Configuration Guidelines, IDE Channel, System Board, Connector Label, Drive Types - hard drive
View all Dell PowerEdge 600SC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
Table 1-1. IDE Drive Configuration Guidelines IDE Channel System Board Connector Label Drive Type(s) 1 PRIMARY IDE Hard drives only. Hard drives on this channel operate in DMA mode at ATA-33, ATA-66, or ATA-100 transfer speeds. 2 SECONDARY IDE Hard drives only. Hard drives on this channel operate in DMA mode at ATA-33, ATA-66, or ATA-100 transfer speeds. 3 THIRD IDE CD, DVD, and tape drives only. Hard drives are not supported. CD and DVD drives operate in DMA mode at ATA-33 transfer speeds. Tape drives operate in PIO mode 3. NOTE: Before installing a hard drive on the secondary IDE channel, you must install one or more hard drives on the primary channel. You cannot install a bootable hard drive on the secondary channel. NOTE: The configuration jumper on all IDE drives must be set to Cable Select. Master and slave jumper settings are not supported. Information Update 1-3