Dell PowerEdge 6450 Rack Installation Guide - Page 21
Installing the Slide Assemblies in the Rack, in this guide.
View all Dell PowerEdge 6450 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
hinge pin hinge insert hinge If you want to reverse the door so that the handle is on the other side, perform the following steps: 1. With the door open, lift out and fully retract all hinge pins. 2. Remove the hinges and door brackets from the door frame. 3. Replace the hinges and door brackets on the opposite side and switch the position of the handle. 4. Replace the rack door (see the section, "Replacing the Rack Doors," found later in this guide). NOTE: If the slide assemblies were preinstalled by Dell, you can skip to the section, "Installing the System in the Rack," found later in this guide. Use the 4-U rack template to determine where you want to install the slide assemblies. The rack template is the same height as the computer chassis. You must allow 4 U (7 inches) of vertical space for each PowerEdge 6x50 system you install in the rack. support.dell.com Dell PowerEdge 6x50 Systems Rack Installation Guide 1-7