Dell PowerEdge FX2 FN I/O Aggregator Release Notes - Page 12
Upgrade the CPLD Image, Command, Command Mode
View all Dell PowerEdge FX2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
www.dell.com | support.dell.com Upgrade the CPLD Image Note: The upgrade fpga-image stack-unit 0 booted command is hidden when using the ? feature in the CLI. However, it is a supported command and will be accepted when entered as documented. To upgrade the CPLD image on an Aggregator: Step 1. 2. Task Command Command Mode Shut down all of the interfaces on the system. Shutting down the ports ensures that the stack-unit power supplies are not disrupted during the upgrade. shutdown INTERFACE Shutting down the ports prior to upgrading ensures that the line card power is not disrupted while the upgrade is taking place. The ports will come back up following the power cycle. Upgrade the CPLD image. upgrade fpga-image stack-unit {0-5} booted EXEC Privilege Dell#upgrade fpga-image stack-unit 0 booted Current FPGA information in the system Card FPGA Name Current Version New Version Unit0 IOM SYSTEM CPLD 6 6 * Warning - Upgrading FPGA is inherently risky and should * * only be attempted when necessary. A failure at this upgrade may * * cause a board RMA. Proceed with caution ! * Upgrade fpga image for stack-unit 0 [yes/no]: yes FPGA upgrade in progress!!! Please do NOT power off the unit Upgrade result Unit 0 FPGA upgrade successful. power cycle the stack-unit to complete the upgrade. Dell# 3. Power cycle the switch (IO module) using the CMC interface or remove and re-insert the switch (OIR) from the chassis so that the CPLD upgrade takes effect. Note: The powercycle stack-unit 0 command does not load the latest CPLD version. 12 |