Dell PowerEdge FX2 FN I/O Aggregator Release Notes - Page 8
boot system stack-unit [0-5 | all] primary, write memory - setup
View all Dell PowerEdge FX2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
www.dell.com | support.dell.com Dell Networking OS version 9.6(0.0) requires FN I/O Aggregator Boot Flash image version 4.0.1.3 and Boot Selector image version 4.0.0.2. If any higher versions of Boot Flash or Boot Selector versions are present in the unit, do not upgrade the Boot Flash and Boot Selector images respectively. The Boot Flash and Boot Selector images can be upgraded at the same time by specifying all in the command. These can be upgraded separately by selecting bootflash-image or bootselector-image respectively. The Boot Flash and Boot Selector images can be upgraded for individual stack units by specifying the particular stack unit ID from the range [0-5] in the command. These can be upgraded to all the stack units together by selecting all option instead of the stack unit ID. The Boot Flash and Boot Selector images can be saved in two partitions A: and B: and the user can select the partition to be upgraded by specifying A: or B: in the command. Dell# upgrade boot all stack-unit all ftp: A: Address or name of remote host []: 10.16.127.35 Destination file name []: FTOS-XL-9.6.0.0.bin User name to login remote host: ftpuser Password to login remote host: Current Boot information in the system: Card BootFlash Current Version New Version Unit0 Boot Flash 4.0.1.1 4.0.1.3 Unit1 Boot Flash 4.0.1.1 4.0.1.3 * Warning - Upgrading boot flash is inherently risky and should only* * be attempted when necessary. A failure at this upgrade may cause* * a board RMA. Proceed with caution !* Proceed Boot Flash image for all units [yes/no]: yes Erasing IOM Primary Bootflash Image, please wait Bootflash image upgrade for all completed successfully. Current Boot information in the system: Card BootSelector Current Version New Version Unit0 Boot Selector 4.0.0.1 4.0.0.2 Unit1 Boot Selector 4.0.0.1 4.0.0.2 Warning - Upgrading boot selectors is inherently risky and should * * only be attempted when necessary. A failure at this upgrade may* * cause a board RMA. Proceed with caution Proceed Boot Selector image for all units [yes/no]: yes !!! Erasing IOM Boot Selector Image, please wait Bootselector image upgrade for all completed successfully. Dell# 6. Change the Primary Boot Parameter of the boot system stack-unit [0-5 | all] primary CONFIGURATION FN I/O Aggregator to the upgraded [system A: | system B: | tftp://] partition A: or B: 7. Save the configuration so that the write [memory] EXEC Privilege configuration will be retained after a reload In case of a stack setup, the configuration will be saved using write memory command. in the Management as well as the standby units. Dell# write memory ! Synchronizing data to peer Stack-unit !!!!!!!! Dell# 8|