Dell PowerEdge FX2 FN I/O Aggregator Release Notes - Page 13
Documentation Errata
View all Dell PowerEdge FX2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
Documentation Errata The following information has to be captured as a new section in the Dell PowerEdge FN I/O Aggregator Configuration Guide: Isolated Networks Isolated Networks feature is supported only on the Aggregator in Standalone mode. This feature allows specifying a global list of VLANs to be designated as Isolated networks. Once specified, the servers that belong to these set of VLANs will not be able to communicate to each other directly within the IOA. All traffic from these servers that belong to Isolated network VLANs will be forwarded to the uplink LAG automatically. The only way the servers can communicate to each other is by being routed at the uplink ToR or beyond. Traffic from the uplink LAG that belong to Isolated network VLANs will be handled the same way as other VLANs, except for unknown unicast and unknown multicast, which will be dropped. This chapter describes the isolated networks configurations in the Dell Networking OS. To configure isolated-network functionality, use the following commands: 1. Enable the isolated-network functionality for a particular VLAN or a set of VLANs. CONFIGURATION mode io-aggregator isolated-network vlan vlan-range Dell(conf)#io-aggregator isolated-network vlan 5-10 To disable the isolated-network functionality, use the no io-aggregator isolated-network vlan vlan-range command. 2. View the VLANs that are configured to be part of an isolated network on an Aggregator. EXEC mode show io-aggregator isolated-networks Dell#show io-aggregator isolated-networks Isolated Network Enabled VLANs : 5-10 | 13