Dell PowerEdge FX2 Dell PowerEdge FN I/O Aggregator Getting Started Guide - Page 4
Introduction, Product Description, Dell PowerEdge FX2 server, chassis Installation Guide - fx2s
View all Dell PowerEdge FX2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
2 Introduction This document provides basic information about the Dell PowerEdge FN I/O Aggregator, including how to install and perform the initial configuration. This document assumes the Dell PowerEdge FX2 server chassis is installed correctly. For complete installation instructions, refer to the Dell PowerEdge FX2 server chassis Installation Guide. For information about how to configure and monitor switch features, refer to the Configuration Guide for the Dell PowerEdge FN I/O Aggregator, which is available on the Dell Support website at http:// www.dell.com/support/manuals. Product Description The Aggregator is a multi-layer, 12x10 Gigabit Ethernet switch that operates in a Dell PowerEdge FX2 server chassis, which supports up to eight servers and two Aggregator switches with four uplink interfaces each. The Dell PowerEdge FX2 server chassis is managed by a single chassis management controller (CMC), which is similar to the CMC unit on the Dell PowerEdge M1000e and provides management connectivity to two I/O modules and the iDRAC units of all eight servers. 4 Introduction