Dell PowerEdge M1000e Fabric OS Command Reference Manual Supporting Fabric - Page 24
Dynamic area mode on default switch, Encryption, Fabric Watch
View all Dell PowerEdge M1000e manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
• fcipPathTest - Revised, updated examples. • turboRamtest - Revised, updated examples. • portLedTest - Updated examples. • portLoopBackTest - - Updated examples. Dynamic area mode on default switch • configure - New option to enable or disable Dynamic Area Mode. • portAddress - Port Address binding is now supported on the default switch as well after you enable Dynamic Area Mode with the configure command. • wwnAddress - Dynamic Area Mode and WWN-Based persistent PID must be enabled on the switch before you can assign an address with this command. Encryption • New command options to support replication for remote host access to data. Supported only with RSA RKM key vault. • CryptoCfg --add - Enhanced to support replication (new -newLUN parameter). • CryptoCfg --decommission - New command group to support device decommissioning. • CryptoCfg --manual_rekey - Modified to support replication (-include_mirror with the -all option). • CryptoCfg --rebalance - Support for combined disk and tape containers on a single Encryption Engine including load balancing for optimized throughput. • CryptoCfg --refreshDEK - Rereads the mirror LUN metadata and updates the FPGA tables for the LUN. • CryptoCfg --set -replication - Configures replication mode. • CryptoCfg --show -container - Enhanced display includes new parameters, "New LUN" and "Replication LUN type". • CryptoCfg --show -groupcfg/-egstatus - Enhanced display "Replication Mode" status and includes diagnostic output to detect incorrectly configured connectivity settings. • CryptoCfg --show -localEE - Enhanced display to show rebalance status. • CryptoCfg --sync -securitydb - Synchronizes security database across encryption group to rectify master key propagation failure. Fabric Watch The interactive Fabric Watch configuration interface (fwConfigure) has been replaced with a command-driven set of new Fabric Watch commands. All Fabric Watch configuration and displays can now be performed non-interactively. The legacy commands will be removed in a subsequent release. • poprtFencing - port and area updates. • portThConfig - Support for VE_Ports and Copper ports added. • sysMonitor - Support for configuring Environment and Resources classes. • thConfig (see new commands) - Configures FW thresholds for the SFP, Fabric, Security, Filter, and End-to-End Performance Monitor classes. xxiv Fabric OS Command Reference 53-1001764-02