Dell PowerEdge M1000e Fabric OS Command Reference Manual Supporting Fabric - Page 686

2 portCfgLossTov portCfgLossTov Synopsis Enables or disables de-bouncing of signal loss for front end ports. portcfglosstov [slot]/port mode Description Use this command to enable or disable the de-bouncing of loss of signal for 100 ms for front end ports. Use portCfgShow to display the current setting. If executed without operands, the command prints the usage. Notes The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may be in place. Refer to chapter 1, "Using Fabric OS commands" and Appendix A, "Command Availability" for details. On a chassis, this command must be executed on the active CP. Operands This command has the following operands: slot For bladed systems only, specifies the slot number of the port to be configured, followed by a slash (/). port Specifies the port to be configured, relative to its slot for bladed systems. Use switchShow to list valid ports. mode Specify 1 to enable the configuration. Specify 0 to disable the configuration. Examples To enable the configuration on port 1/5 and to display the configuration: switch:admin> portcfglosstov 1/5 1 switch:admin> portcfgshow 1/5 Area Number: 5 Speed Level: AUTO(HW) Fill Word: 0(Idle-Idle) AL_PA Offset 13: OFF Trunk Port ON Long Distance OFF VC Link Init OFF Locked L_Port OFF Locked G_Port OFF Disabled E_Port OFF Locked E_Port OFF ISL R_RDY Mode OFF RSCN Suppressed OFF Persistent Disable OFF LOS TOV enable ON NPIV capability ON QOS E_Port AE Port Auto Disable: OFF Rate Limit OFF EX Port OFF Credit Recovery ON F_Port Buffers OFF NPIV PP Limit: 126 CSCTL mode: OFF 654 Fabric OS Command Reference 53-1001764-02