Dell PowerEdge M605 Fabric OS Command Reference Manual Supporting Fabric - Page 175

configureChassis 2 Custom Attributes Table 15 lists custom attributes that may be modified. TABLE 15 Configurable custom attributes Application Attribute Custom Config Index (0 to ignore): Type Number Default 0 Range 0-10000 config Index OEM custom configuration. This attribute is for internal use only. System Settings The following system-related parameters are configurable on a Virtual Fabric-aware switch. TABLE 16 System Settings Field Type Default Range system.blade.bladeFaultOnHwErrMsk Number 0x0 system.cpuLoad Number 121 0x0 to 0xffff 10 to 121 system.blade.bladeFaultOnHwErrMsk If this field is set to a value other than 0, then any nonfatal HW ASIC data parity error causes the problem blade to be powered off. system.cpuLoad Sets a threshold to define internally when the CPU is busy. The default threshold is 121, which represents a CPU instantaneous load average of 1.21 in the uptime or top command. The range is 10 through 121 (representing CPU load thresholds of .10 through 1.21). Examples To enable signature validation for downloading firmware: switch:admin> configurechassis Configure... cfgload attributes (yes, y, no, n): [no] \fBy\fR Enforce secure config Upload/Download (yes, y, no, n): [no] Enforce signature validation for firmware (yes, y, no, n): [no] Custom attributes (yes, y, no, n): [no] \fBy\fR Config Index (0 to ignore): (0..1000) [0] system attributes (yes, y, no, n): [no] \fBy\fR system.blade.bladeFaultOnHwErrMsk: (0x0..0xffff) [0x0] system.cpuLoad: (10..121) [121] See Also configDefault, configShow, chassisEnable, chassisDisable, configure, ipAddrSet, portCfgLongDistance, switchDisable, switchEnable, upTime Fabric OS Command Reference 143 53-1001764-02