Dell PowerEdge M605 Fabric OS Command Reference Manual Supporting Fabric - Page 181

cryptoCfg 2 host_username Specifies the user name for the host. Depending on your host configuration, this command may prompt for a password. host_file_path Specifies the fully qualified path of the file to be imported. The path must include the file name. -usb Imports a file from a mounted USB storage device. This command is valid only on nodes with an attached USB device. When -usb is specified, the following operands are required: dest_filename Specifies the name to be assigned to the imported file. This is a user-generated file name. source_filename Specifies the name of the certificate on the USB storage device from which you are importing. --reg -membernode Registers a member node with the group leader. This command is valid only on the group leader. The encryption group must have been created prior to performing member node registration. All member nodes and group leaders must be registered before encryption group discovery and formation can occur. The order in which member node registration is performed defines group leader succession. At any given time, there is only one active group leader in an encryption group. The group leader succession list Specifies the order in which group leadership is assumed if the current group leader is not available. The following operands are required when registering a member node with the group leader: member_node_WWN Specifies the switch world wide name of the member node. member_node_certfile Specifies the member node CP certificate. You must have exported this file earlier to external storage and then imported it to the group leader before you can register a member node. Use cryptocfg --show -file -all to view all imported certificates. member_node_IP_addr Specifies the IP address of the member node to be registered with the group leader. --dereg -membernode Removes the registration for the specified member node. This command is valid only on the group leader. The node is identified by the switch WWN. member_node_WWN Specifies the member node by its switch WWN. This operand is required when removing a node registration. Fabric OS Command Reference 149 53-1001764-02