Dell PowerEdge M710HD Fabric OS Command Reference Manual Supporting Fabric - Page 64
To set and display failover and failback policies on a single port
View all Dell PowerEdge M710HD manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 64 highlights
2 ag 32 switch:admin> ag --prefdel 5 2 Preferred N_Port is deleted successfully for the F_Port[s] switch:admin> ag --mapdel 2 "5" F_Port to N_Port mapping has been updated successfully NOTE: Preferred Port commands are discussed in detail below. AG failover policy commands To display failover policy settings for all N_Ports: switch:admin> ag --failovershow N_Port failover_bit 0 1 1 0 2 1 3 0 To set and display failover and failback policies on a single port: switch:admin> ag --failoverenable 1 Failover policy is enabled for port 1 switch:admin> ag --failoverdisable 0 Failover policy is disabled for port 0 switch:admin> ag --failovershow 0 Failover on N_Port 0 is not supported switch:admin> ag --failbackdisable 2 Failback policy is disabled for port 2 admin> ag --failbackshow 2 Failback on N_Port 2 is not supported switch:admin> ag --failbackenable 2 Failback policy is enabled for port 2 To display failback policy settings for all the N_Ports: switch:admin> ag --failbackshow N_Port failback_bit 0 0 1 1 2 0 3 1 To set and display failback policy settings on a single port: switch:admin> ag --failbackenable 0 Failback policy cannot be enabled since failover policy is disabled for port 0 switch:admin> ag --failbackenable 2 Failback policy is enabled for port 2 switch:admin> ag --failbackenable 3 Failback on N_Port 3 is not supported Fabric OS Command Reference 53-1001764-02