Dell PowerEdge M910 Fabric OS Command Reference Manual Supporting Fabric - Page 647

portCfg 2 portcfg ipif [slot/]ge_port option arguments Valid options and arguments for ipif are: create src_ipaddr [netmask] mtu_size Creates IP interfaces. Specify the following: src_ipaddr Specifies source IP address in either IPv6 or IPv4 format: src_IPv6_addr/prefix_len Specifies the source IPv6 address of the virtual port if IPv6 is used. The address must be an IPv6 global, unicast address, followed by a prefix. This is used for IPv6 addresses instead of a netmask. The prefix_len operator is required. Refer to the Fibre Channel over IP Administrator's Guide for more information on IPv6 rules and restrictions. src_IPv4_addr netmask Specifies the source IPv4 address of the virtual port, if IPv4 is used. If an IPv4 address is used, the subnet mask must be specified as well (in a.b.c.d. format.) mtu_size Specifies the maximum transmission unit size. The permitted range is 1260 Bytes to 1500 Bytes for the Brocade 7800/FX8-24 platforms and 1260 Bytes to 2348 Bytes for the Brocade 7500/7500E/FR4-18i. This operand is required. delete ipaddr Deletes IP interfaces. Specify the IPv6 or IPv4 address of the virtual port. iproute Defines static IP routes on a GbE port or on a 10GbE port. After defining the IP interface on the remote switch, you can define destination routes for an interface. A maximum of 32 user-configurable routes per GbE/10GbE port are supported. You cannot use this command to configure routes for inband management; use portCfg inbandmgmt instead. The syntax for portcfg iproute is as follows: portcfg iproute [slot/]ge_port option arguments Valid options and arguments for iproute are: create dest_ipaddr [netmask] [gateway_router] metric Creates an IP route. Specify the following: dest_ipaddr Specifies the destination IP address in either IPv6 or IPv4 format: dest_IPv6_addr/prefix_len Specifies the destination IPv6 address of the virtual port, if IPv6 is used. The address must be an IPv6 global, unicast address, followed by a prefix. This is used for IPv6 addresses instead of a netmask. The prefix_len operand is required. dest_IPv4_addr netmask Specifies the destination IPv4 address of the virtual port, if IPv4 is used. If an IPv4 address is used, the subnet mask must be specified as well. Use a.b.c.d. format. Fabric OS Command Reference 615 53-1001764-02