Dell PowerEdge MX7000 EMC PowerEdge MX7000 Enclosure Installation and Service - Page 25
KVM limitations
View all Dell PowerEdge MX7000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
Table 9. KVM supported RACADM commands(continued) Command Description debug Enables the debug authorization commands. deploy Deploys the blade or IOM with specified properties. faultlist Displays the active messages in the chassis subsystem. getniccfg Displays the current network settings. getsensorinfo Displays the system sensor information. getsysinfo Displays the general management module and system information. getpminfo Displays the power management status information. getpbinfo Displays the power budget status information. racreset Performs a management module reset operation. racresetcfg Performs a management module factory reset operation. swinventory Displays the list of software's installed on the chassis. serveraction Perform a server or storage power management operation. setniccfg Modify the network configuration properties. traceroute Displays the route packets trace to network host. traceroute6 Displays the IPv6 route packets trace to network host. ifconfig Displays the network interface information. ping Sends ICMP echo packets on the network. ping6 Sends IPv4 ICMP echo packets on the network. getconfig Displays the management module configuration properties. config Modify the management module configuration properties. chassisgroup Enables multiple chassis management. KVM limitations The KVM features are disabled in the following scenarios: • If the iDRAC is undergoing a reset process. • If the management module is undergoing a reset process or not active. • The OSD is blank until the management module is active. • DP - DVI and DP - HDMI are not supported by the PowerEdge MX7000 KVM solution. • The maximum resolution that is supported by the PowerEdge MX7000 are: ○ 1920 x 1200, 32 bits per pixel @ 60 Hz ○ 1600 x 1200, 32 bits per pixel @ 75 Hz For more information about the PowerEdge MX7000 at the box serial access feature of the chassis management firmware , see PowerEdge MX7000 At-the-Box Serial Access to Management Firmware For more information about the PowerEdge MX7000 supported RACADM Commands, see Dell EMC OpenManage Enterprise Modular Edition Version 1.00.01 for PowerEdge MX7000 Chassis Initial system setup and configuration 25