Dell PowerEdge MX7000 EMC PowerEdge MX7000 Enclosure Installation and Service - Page 35

Installing a rear fan module, Power supply units, Removing a power supply unit

Get Dell PowerEdge MX7000 PDF manuals and user guides View all Dell PowerEdge MX7000 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 35 highlights

Next steps 1. Install the rear fan module. Installing a rear fan module Steps 1. Insert the fan module into the fan bay. 2. Push the fan module into the fan bay, until it locks into place. NOTE: Ensure that the green LED on the fan module is illuminated, indicating that the module is functioning properly. Figure 23. Installing a rear fan module Power supply units Removing a power supply unit Prerequisites CAUTION: At least two power supply units (PSUs) must be installed for the enclosure to function properly. 1. Follow the safety guidelines listed in Safety instructions. 2. Disconnect the power cable from the power connector associated to the PSU you intend to remove. Steps 1. Press the orange release button to open the PSU release lever. 2. Hold the release lever, pull the PSU out of the enclosure. CAUTION: Ensure that you install a PSU blank if you are removing a PSU permanently. Installing and removing system components 35

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
Next steps
1.
Install the rear fan module
.
Installing a rear fan module
Steps
1.
Insert the fan module into the fan bay.
2.
Push the fan module into the fan bay, until it locks into place.
NOTE:
Ensure that the green LED on the fan module is illuminated, indicating that the module is functioning
properly.
Figure 23. Installing a rear fan module
Power supply units
Removing a power supply unit
Prerequisites
CAUTION:
At least two power supply units (PSUs) must be installed for the enclosure to function properly.
1.
Follow the safety guidelines listed in
Safety instructions
.
2.
Disconnect the power cable from the power connector associated to the PSU you intend to remove.
Steps
1.
Press the orange release button to open the PSU release lever.
2.
Hold the release lever, pull the PSU out of the enclosure.
CAUTION:
Ensure that you install a PSU blank if you are removing a PSU permanently.
Installing and removing system components
35