Dell PowerEdge PDU Metered LCD Cabling PowerEdge R610 - Page 7

Cabling the Dell™ PowerEdge™ R610 4. Once all the cables are routed through the CMA, dress the cables between the back of the system and the entrance of the CMA with the tie wraps provided in the CMA kit. The tie wraps are shown in yellow in all illustrations. 5. Clip off the excess length of material from the tie wraps and make sure that the tie wraps are positioned to avoid interference with adjacent systems. 6. Return the CMA to the closed (retracted) position. 7. Extend the system from the rack to verify there is sufficient slack in the cables at both the entrance and exit of the CMA. 8. See Figure 5 for an example of a completed left side mounted CMA installation. Figure 5: Completed Left Side Mounted CMA Installation Right Side Mounting Instructions Install the CMA on the right rear side of the rails by attaching both CMA housings to the attachment brackets on the rails. Follow steps 2‐7 from the right side mounting instructions in the previous section. See Figure 6 for an example of a completed right side mounted CMA installation. Figure 6: Completed Right Side Mounted CMA Installation Page 5