Dell PowerEdge PDU Metered LCD Cabling PowerEdge R610 - Page 9
Replacing a Power Supply on a PowerEdge R610 with CMA
View all Dell PowerEdge PDU Metered LCD manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
Cabling the Dell™ PowerEdge™ R610 Replacing a Power Supply on a PowerEdge R610 with CMA 1. Remove the tray from under the CMA as described in the CMA Installation Instructions provided with the CMA kit. 2. Swing the CMA into the service position. 3. Disconnect the power cord from the power supply and disengage the strain relief. 4. Remove and replace the power supply a. If the CMA is attached to the left side, both power supplies can be removed without disconnecting the CMA. b. If the CMA is attached to the right side and the inner power supply needs to be replaced, the CMA does not need to be disconnected. c. If the CMA is attached to the right side and the outer power supply needs to be replaced, the inner CMA attachment housing will need to be disconnected. While supporting the CMA with one hand, remove and replace the power supply with the other hand as shown in Figure 9. Figure 9: Replacing Outer Power Supply Inner CMA attachment housing has been disconnected 5. Plug in the power cord. 6. Re‐engage the strain relief. 7. Return the CMA to the closed (retracted) position. Page 7