Dell PowerEdge R6525 EMC Technical Specifications - Page 27

Table 36. iDRAC Quick Sync 2 indicators and descriptions iDRAC Quick Sync 2 indicator code Off (default state) Solid white Blinks white rapidly Condition Corrective action Indicates that the iDRAC Quick Sync 2 feature is powered off. Press the iDRAC Quick Sync 2 button to power on the iDRAC Quick Sync 2 feature. Indicates that iDRAC Quick Sync 2 is ready to communicate. Press the iDRAC Quick Sync 2 button to power off. Indicates data transfer activity. If the LED fails to power on, reseat the left control panel flex cable and check. If the problem persists, see the Getting help section. If the LED fails to power off, restart the system. If the problem persists, see the Getting help section. If the indicator continues to blink indefinitely, see the Getting help section. Blinks white slowly Indicates that firmware update is in progress. If the indicator continues to blink indefinitely, see the Getting help section. Blinks white five times rapidly and Indicates that the iDRAC Quick Sync 2 then powers off feature is disabled. Solid amber Blinking amber Indicates that the system is in fail-safe mode. Indicates that the iDRAC Quick Sync 2 hardware is not responding properly. Check if iDRAC Quick Sync 2 feature is configured to be disabled by iDRAC. If the problem persists, see the Getting help section. www.dell.com/ poweredgemanuals or Dell OpenManage Server Administrator User's Guide at https:// www.dell.com/openmanagemanuals. Restart the system. If the problem persists, see the Getting help section. Restart the system. If the problem persists, see the Getting help section. iDRAC Direct LED indicator codes The iDRAC Direct LED indicator lights up to indicate that the port is connected and is being used as a part of the iDRAC subsystem. You can configure iDRAC Direct by using a USB to micro USB (type AB) cable, which you can connect to your laptop or tablet. Cable length should not exceed 3 feet (0.91 meters). Performance could be affected by cable quality. The following table describes iDRAC Direct activity when the iDRAC Direct port is active: Table 37. iDRAC Direct LED indicator codes iDRAC Direct LED indicator code Condition Solid green for two seconds Indicates that the laptop or tablet is connected. Blinking green (on for two seconds and off for two seconds) Indicates that the laptop or tablet connected is recognized. Powers off Indicates that the laptop or tablet is unplugged. LCD panel The LCD panel provides system information, status, and error messages to indicate if the system is functioning correctly or requires attention. The LCD panel is used to configure or view the iDRAC IP address of the system. For information about the event and error messages generated by the system firmware and agents that monitor system components, go to qrl.dell.com > Look Up > Error Code, type the error code, and then click Look it up.. The LCD panel is available only on the optional front bezel. The optional front bezel is hot pluggable. The status and conditions of the LCD panel are outlined here: • The LCD backlight is white during normal operating conditions. • If there is an issue, the LCD backlight turns amber and displays an error code followed by descriptive text. System diagnostics and indicator codes 27